Project Description

Features

    • Very low output ripple and spikes
    • EMC surpasses CE requirements: low emission & high immunity
    • High programming speed
    • Excellent dynamic response to load changes
    • Protected against all overload and short circuit conditions
    • Designed for long life at full power

Functionalities

    • Master / Slave parallel and series operation with voltage and current sharing
    • Voltage and current control with 10 turn potentiometers
    • For laboratory use or optional 19” rack mounting

Specifications

Single phase input 92-265 V AC (48-62 Hz)
Active Power Factor Correction (PFC) 0.99 / 0.96 (at 100% load)
Efficiency up to 86% (at full load)
Output ripple and spikes from 5 mVrms / 15 mVpp
Regulation from 10 mV (0-100% load step)
Recovery time from 50 μs (50-100% load step)
Programming speed from 0.8 ms (10-90%)
Analog programming accuracy from 0.2%
Output voltage and current stability 30.10-5 / 10.10-4
MTBF 500.000 hrs
Operating ambient temperature -20 to +50 °C

Standards

Power supply standard EN 61204-3
Generic Emission EN 61000-6-3 (EN 55022B)
Generic Immunity EN 61000-6-2
Safety EN 60950 / EN 61010
Insulation input / output 3750 Vrms
Enclosure IP20

Dimensions and Weight

Width = ½ 19
Height = 66 mm (incl. feet)
Depth = 333 mm
Weight = 3.1 kg

Available units

Partnumber Voltage range Current range
ES 030-10 0 – 30 V 0 – 10 A

Options

Increased Output Power
The conservatively rated unit allows todeliver extra output power with the same reliability. At some derating,either the maximum output voltage or the maximum output current can be increased by about 10%.
High Voltage Isolation (up to 1000 V)
A higher output isolation allows series operation up to1000 V.
Sequencer
Arbitrary Waveform generator or standalone automation. The sequencer is integrated in the Ethernet controller.
19 Inch Rack Mounting Adapter
Using the 19 inch mountingadapters, it is possible to position the ES units in a 19 inch rack.
Several configurations possible with multiple ES and / or PSC or ISO AMP modules.
Rear Power Output and Remote Sensing
Output terminals at the rear panel instead of bind posts at the front panel, includes remote sensing.
Software Control and Interfaces
Factory installed programming interfaces:

  • Ethernet controller (incl. sequencer)
  • PROFIBUS controller
  • CANBUS controller
  • RS232 controller
 External programming interface modules:

  • IEEE448 controller module
  • ISO AMP module

Downloads

Downloads Document format Size
Data sheet ES300-Series PDF (Acrobat Reader) 384.0 KB
Data sheet Ethernet interface PDF (Acrobat Reader) 73.6 KB
Data sheet IEEE488 & RS232 interface PDF (Acrobat Reader) 153.7 KB
Data sheet ISO AMP option SM-Series PDF (Acrobat Reader) 86.5 KB
Data sheet PROFIBUS & CANopen interface PDF (Acrobat Reader) 129.6 KB